Standard Garage Door Sizes in Ontario and How to Measure
Most Ontario homes use one of a few common sizes: roughly 8 or 9 feet wide for a single door, and 16 feet wide for a double, with 7 feet being the usual height and 8 feet common on taller openings. Older homes and custom builds often differ, so the reliable answer is always to measure your own opening rather than assume.
What are the most common garage door sizes?
The common residential sizes are 8 by 7 feet and 9 by 7 feet for singles, and 16 by 7 feet for doubles, with 16 by 8 feet and 18 by 7 feet turning up on larger or newer homes. Garage doors are sold in standard widths and heights, which keeps panels, tracks and hardware interchangeable and makes replacement simpler.
Why are older GTA garages often different?
Older houses were built around smaller cars, so many bungalows and early subdivision homes have narrower single openings, sometimes 8 feet wide or less. Some have been altered over the years as well. If your garage predates modern standards, the opening may sit between two standard sizes, which affects what can be fitted without framing changes.
How do I measure my garage door opening?
Measure the width and height of the finished opening from inside the garage, and note the exact figures. Take the width at the top, middle and bottom, and the height on both sides and in the middle, because older openings are often slightly out of square. Use the smallest figure as your working number and write down each reading.
What is headroom and why does it matter?
Headroom is the clear space between the top of the opening and the ceiling or the nearest obstruction, such as a beam, pipe or light. It decides where the spring system and tracks can sit, and whether a standard lift or a low-headroom setup is needed. It is one of the first things we check, and the main reason a door that looks like a straightforward swap sometimes is not.
What about side room and depth?
The tracks need clear space on each side of the opening, and the open door needs enough depth to travel back along the ceiling. Tight side room can limit the door or hardware choice, and a short garage may restrict how far the door rides back. These details matter just as much as the opening itself when a new door is being specified.
Can I change the size of my garage door?
Yes, but changing the opening is structural work. Making it wider or taller means replacing the header that carries the load above it, plus reframing and finishing the surrounding wall. Keeping the existing opening is far simpler, and a door can usually be made to suit it. If you are weighing a bigger opening, read our note on whether to choose a double door or two singles first.
What if my opening is not a standard size?
A door can be built to a non-standard size, which is common on older homes, heritage properties and custom builds. It takes longer to order and the size is set for your opening only, so accurate measurements are essential. Custom sizing is one of several factors that shape the final quote, which we cover in our guide to the factors that set garage door cost.
Does door size affect the opener?
It can. A wide, heavy or insulated door puts more load on the opener, and a taller door needs a longer rail or a suitable travel length. The door weight and height should be matched to the opener's rating. See our overview of garage door opener installation for what to expect.
What should I write down before calling?
Opening width and height, measured in several places.
Headroom above the opening and any obstructions.
Space on each side of the opening, and the depth of the garage.
A photo of the door from inside and outside.
Get your door measured by Modern Empire Doors
Modern Empire Doors, at 138 Yorkland St, Richmond Hill, has served the GTA since 2018 and is top rated on Google. Call 647-323-1826, any time, 24/7. Send a photo of your door from inside and outside along with your measurements and we will confirm what fits.



Comments